Bed Holder Ender 5 Plus Remix

thingiverse

The original part designed be Xerber https://www.thingiverse.com/thing:4727217 did not work with my Ender 5+, my Z rails are an extruded aluminum design and have an extra bit on the edge, instead of the flat bars pictured on the original design. The Y bed holders from the original design work fine for my PEI print bed, make aligning the bed back in place nice and easy after removal. I redesigned the X holders to screw down to the cross bars that the bed is attached to using M4 x 12 screws and T-nuts. The outer bed screw can be removed and the T-nut slid in from the end, or use hammer t-nuts. I've uploaded a version also without the locating pin, this will enable the piece to be printed without supports, I just preferred the pin as it keeps the bed holder securely located.