Bed Frame Wheel Chock

thingiverse

To prevent my bed frame from rolling on the wood floor without raising it, I created a device that captures and holds a wheel slightly off the ground. The bottom of this device has slots to keep the wheel close to its original height, ensuring that the center brace, which is not a wheel, doesn't need alteration. To maintain a consistent look, I used the same felt as other parts without needing additional printing. For my 3D print, I chose ABS material, sliced at 0.25mm layer thickness with four perimeters and honeycomb infill. To cover the two felt pads needed for this device, simply cut a standard 4" x 6" felt pad in half using scissors.