Bed Clamp for Ender 3 with 4mm Glass bed

thingiverse

Clamps To Secure The Creality Glass Bed On An Ender 3 Printer Firmly In Place. The 4mm Thick Glass Bed Requires Seven Of These Clamps For Maximum Stability. Avoid Placing One Clamp On The Lower Left Side, As The Nozzle May Come Into Contact With It, Causing It To Be Knocked Off. Four Clamps Can Be Sufficient, But Adding More Provides Extra Security. A Revised Version, V2, Incorporates Small Bumps That Enhance Grip And Provide A Tighter Fit If Needed. Additionally, A Corner Version Is Available For Added Convenience. Important Considerations: When Printing With PLA And Heating The Bed, These Clamps Tend To Release After Approximately Three Prints. It's Advisable To Print The Clips Using ABS For Use In Printing PLA, Especially If The Bed Will Be Heated. However, If The Bed Is Not Being Heated, The Clamps Remain Secure Throughout The Printing Process.