Bebop Landing Gear

myminifactory

LandingGear_ULLR - Print 2 copies for upper-left and lower-right legs.LandingGear_URLL - Print 2 copies for upper-right and lower-left legs.Starting with the 7th image in the gallery:After printing the 2 halves of the landing gear, take a standard pushpin and remove its plastic part by breaking it off. Then cut off the sharp end to leave an 11mm rod. Glue the 2 halves together with the pin in the channel as shown.Take a 4.8mm zip tie for each of the 4 springs and a 2.2mm zip tie for securing the assembly to the bebop legs.Insert the 4.8mm zip tie through the landing gear as shown, then pull it until its buckle pops into place.Curl the tip of the zip tie as much as possible, loop it around, and insert it into the other end of the landing gear's slot. Push until the tip comes through its buckle (Image 11). If it doesn't fit, curl the tip tighter and try again.Pull the zip tie through until you achieve the desired spring size. Cut the excess tie at the buckle.Remove the rubber feet from each leg and insert the appropriate landing gear post through the hole at the bottom. Secure the assembly with a 2.2mm zip tie as shown.