Bebop 2 SkyController mount

thingiverse

This is a carrier that enables the Bebop 2 drone to be stored and transported on the Sky Controller 2. The carrier simply clicks into the phone holder, then the clips secure the main cross frame in place. There's a center raised section that assists in centering the drone on the mount, and you can clip a lanyard onto the metal ring on the phone adapter to carry it by a strap. The locking action to the drone is very secure and may require the drone and carrier to be removed from the controller before removing the adapter from the drone bottom with a slight bending of the adapter, but not much. Print Settings Printer: da Vinci 1.0Plus Rafts: No Supports: Doesn't Matter Resolution: .2 layer Infill: 50% Notes: Printed on a daVinci 1.0PLus using ROBO 3D Black ABS. Use of supports is recommended since the center frame locator has about 1/8 inch gap between it and the build platform but because it is such a small area a good printer may not need them at all, otherwise no other supports are needed or generated. Printed using .4mm nozzle, .2 layer height, 50% octogon infill with thick shells. With extrusion set at slow took approx 4 hrs 27 min.