Beat Saber Handles for Oculus Quest 2

thingiverse

*Work In Progress - Not responsible for any damage to controllers or surroundings* **Beat Saber Grips for Oculus Quest 2 Touch Controllers** Goals/Features: * Quick installation/removal * Uses existing wrist straps * Grip position close to default controller grip. Long handle not desired * Elongated handle cross-section to prevent rotation in hand * Slight curve and taper to handle * Flared base for pinky, but minimal flare by palm to prevent rubbing Only right hand model provided. Handle must be mirrored for left hand. Handle prints without supports. Used a brim only on the outside for bed plate adhesion. Interior corner of handle base is rounded to prevent wear on wrist straps. Smooth out any ridge due to printing. Small latch had best results with minimal overhang raft and supports. Latch has fairly tight clearances so setting tweaks may be needed. Printed in PLA so far. PETG, ASA, ABS may be desirable for durability. I am concerned about the small latch creeping over time with PLA and losing solid clamping on the controller. Another material may resist this better. However, printing a replacement latch is easy. Intending to cover handle in some form of overgrip tape. May try printing the exterior with "fuzzy skin" texturing.