Bearing Puller

A tool for pulling bearings from various housings, such as motorbike bearings.



Instructions
Break off support structure at entrance to nut trap hole
Slip nut into nut trap.
Insert 8mm threaded rod (about 600mm should do) into the bottom
Twist threaded rod through the nut and into the teeth at the end until tight
Insert the teeth into the inside of your bearing
Tighten the threaded rod till its very tight (But dont break the teeth!)
Pull upwards like crazy (Or better yet, put a nut on your threaded rod and a block of wood with an 10mm hole in it and then use it as a hammer to bang upwards onto the nut.
Its parametric, but currently configured to do the bearings on my dirt bike.