BCN3D Sigma R16 to R20 screen frame adapter

prusaprinters

So I cracked my original screen of the BCN3D Sigma R16, and bought the r20 screen in a rush, expecting that assembly would be hassle-free, but found out that it's not a plug-and-play affair. Designed with a calliper, eyeballing some measurements, and iterating the design two times I came up with this, it could use some improvement, but it does serve the function well enough now. The back insert is friction-based, but the screen frame is a bit loose and it could use some sort of adhesive/glue, I personally used reusable sticky putty (Tack-It from Fabre Castell) on both the screen frame and the back insert for extra assurance. Print Settings Printer: Artillery Sidewinder X1 Rafts: No Supports: Yes Resolution: 0.32 Filament: Fillamentum PLA Rapunzel Silver Notes: Software Used: Cura 4.6.1 Quality: Line Width: 0.48mm (from a 0.4mm nozzle) Initial Layer Line Width: 150% Shell: Wall Line Count: 2 Top Layers: 3 Bottom Layers: 2 Top/Bottom Pattern: Zig Zag Infill: Density: 8% Pattern: Zig Zag Speed: Print Speed: 100mm/s Wall Speed: 80mm/s Outer Wall Speed: 60mm/s Print Acceleration: 650mm/s^2 Travel Acceleration: 800mm/s^2 Experimental: Enable Conical Support Category: 3D Printer Parts