Bauhaus Tray - Ikea Fejka Modules

prusaprinters

A set of modules for AndrzejG's Bauhaus Tray, that allows the addition of ⌀5cm and ⌀6cm vase Ikea Fejka plants.Includes a model for the plant, and one that also accomodates the fake dirt patch (+ an additional one with higher tolerances) You will need to remove the plant from its vase (be careful as the stem is attached with hot glue). Do it gently and without twisting too much, or you might ruin the stem.Depending on the model, the plant stem could have two tabs on each side. You'll probably need to cut them off with a blade. Do it a bit at a time to make sure you get the best pressure fit.Some stems are longer, some are shorter, and some of the dirt patches feature a pressure fit peg. These seem to be quite inconsistend between models, so make sure to test stuff before cutting parts off. The dirt patch with the additional peg requires it to be cut, while the patch with just the hole is fine as is.All of the plants and patches I own are ⌀5.2cm (vase is ⌀5.5cm), even if some are sold as ⌀5 and some as ⌀6. This means that this model should fit all plants sold as ⌀5 and ⌀6. The plant stems are the same size, so it should fit all these models: