Battrey Spacer for Traxxas LCG & HCG 2wd Slash

thingiverse

I designed a battery spacer, which I had 3D printed out at one of my local hobby shops to replace the two-piece foam spacers I use to fill in the gap between the lipo battery and the chassis of this traxxas 2wd slash that you can see in these photos if you want to download this RC accessory. You don't need much, just a good 3D printer and your battery must be 137.29mm in length as far as hard case lipos are concerned. And it has to be a traxxas 2wd slash LCG or HCG. You may need double-sided tape depending on what you did to your chassis but in my case, there was no need for me to do that because it fits tightly and I wouldn't worry about it falling off. So enjoy this RC accessory.