BATTERY STORAGE BOXES (PRINT-IN-PLACE

cults3d

Who else got big fingers? I've created these boxes to store my batteries and accommodate my big fingers. Its a print in place design, so no assembly is required on the box. The only thing you'll have to do is glue the logo on the top. That's it. Three designs included: -24x AAA -24x AA -DUAL: 12x AAA and 12x AA in the same box. Everything is already placed in the right orientation. Print-in-place means: Test your printer. You have a tolerances of 0.3mm almost everywhere, so a well calibrated printer is the key. Also, the letters on top are recessed. But when its printing against the bed, it means they have to bridge over the whole letter. So your bridging settings must be good too. Finally, the latch will be hard to snap at the beginning. Use a sanding paper to gently adjust the latch by sanding the inside of the clipping loop. Don't do it too much, or else it won't snap anymore!!!!! If you have any problems, as usual you can contact me here or directly on my facebook page: https://www.facebook.com/PA1MAKER For full access to all my models and for a commercial license to sell your prints, see my Patreon: https://www.patreon.com/PA1_MAKER