Battery Plate, Accessory Plate, and Torsion Block for ARX V2 Race Frame
thingiverse
###**July 20, 2019: Added Torsion Blocks**### These blocks go between motor mounts and keep spar ends in place while absorbing energy during crash impacts (see pictures). These should be printed at 50% infill for all four combined. The weight is 1.8g. ###**Added "Horny" Canopy for Turtle Mode Users**### ###**Updated ARX V2 Frame Pod**### I made changes to the model: The canopy sits on center plate tabs now Camera mounting holes were moved back for better protection Cooling vents were added Larger front cutouts were added for front motor wires Platform was added to zip tie vtx antenna The canopy fits any camera size between 14x14 and 20x20. ###**Flimsy Until Mounted**### The pod feels a bit flimsy, but it's sturdy once the camera is installed and mounted on the frame. This works as long as TPU hardness is not lower than 95a. ###**Model Notes**### I've only had a printer for three months, so this may not be the best solution: To get a clean bottom edge, I don't use a brim (just a few skirt lines). Instead, I made a brim that connects to the inside wall. The outer edges still lift up slightly (less than 1mm) but it doesn't affect the print since this happens when the pod is about 4-6mm in print height.
With this file you will be able to print Battery Plate, Accessory Plate, and Torsion Block for ARX V2 Race Frame with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Battery Plate, Accessory Plate, and Torsion Block for ARX V2 Race Frame.