Battery cases for Fujifilm NP-95 batteries

thingiverse

This battery holder is engineered to accommodate Fujifilm NP-95 batteries securely. The design tolerances ensure compatibility with both original and third-party batteries featuring slightly thicker wrapping due to variations in packaging. A prominent hole at the rear facilitates easy removal of the batteries, while a delicate edge on the front prevents them from falling out prematurely. This holder is not intended as a dust cover but rather serves to neatly organize the batteries and segregate empty ones from fully charged ones effectively. Printing this design should yield satisfactory results. I achieved consistent outcomes when using an Original Prusa i3 MKII with the following settings: Sliced with Simplify3D software Printed upright, with the back facing down on the print bed Used PLA material Employed a 0.4mm nozzle Constructed with two shells for added strength Set to zero infill to achieve flexibility, although experimentation with varying infill levels is possible Applied five layers of top and bottom surfaces to stiffen the front and back sides