Battery case 18650 with room for charger and step-up converter

prusaprinters

A battery case for 18650 Lipos with room for a perfboard 80x20 mm (e.g. to house both a charge circuit and a step-up converter). Cutout for a 12x19 mm switch to separate the (+) output of the charger/protector from the input of the step-up converter. Parts used: Perfboard 80x20 mm USB LiPo Charger/Protector TP 4056 (board version with integrated output overload/undervoltage cutoff) Step-Up Converter MT 3608. On/Off switch snap-in for cutout 19x12 mm, 250V / 3A, height beneath front panel 19mm. Assembly: both boards soldered with 0,7 wire as stand-off onto the perfboard. use the battery terminals of the TP4056 board as contact points use some loops of uncoated copper wire around the plastic springs for the battery terminals. use isolated wire to connect the loops to the battery terminals of the TP4056 connect ground/minus directly between TP4056 output pad and MT3608 input pad connect plus through the on-off switch. Can be made with 6.35 mm crimp connectors if you cut off the crimp part and solder the wires along the cut line. Print Settings Printer: TronXY X5S Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.6 mm nozzle, 0.25 mm layer height Infill: 15% Filament: Generic budget PLA gray transparent Category: Electronics