Battery Base Tile and Torch

prusaprinters

Based on the Torch Wall model from the OpenForge project, use the negative STL in your slicer to cut out a spot for the battery holder, torch, access to the power switch, and a path for the wires to connect them. BOMCR2032 coin cellsCR2032 coin cell holders with power switch3mm flickering LED1/8" or 3mm heat shrinkInstructionsUse “Torch and battery negative.stl” in your slicer as a negative volume to cut a space in your wall tile and printPrint “3mm Torch.stl”Run battery holder leads through printed wall part out to torch cutout, trim to reasonable length to work with, and place a short length of shrink over at least one wire.Push the LED legs through the torch, solder long LED leg to red, short leg to black, and cover at least one joint with shrink.Pull torch into wall and press fit into place. Press fit battery holder into base bottom, it should be very tight. Stuff slack wire into wall.Drop a ball of hot glue on the LED and have fun making it look like fire