Battery 22v SainSmart / TS100

thingiverse

Hello everyone, I printed this way: Head: 215° Bed: 60 Speed: 45mm/s Black PLA Arianeplast Infill: 100% You don't have to print at 100% (I do 100% because I don't want it to distort if it stays in my car not hot weather). Please make sure your printer is properly calibrated because the model is quite accurate in the measurements. For the XT30U connector, you will need to glue it with epoxy glue. The cable used for the XT30U is AWG 20 (if you take bigger, you will have to drill a little). For the box, it will tap in M3. You will need: 4x M3 / 12mm long 8x M3 / 10mm long The battery has a capacity of 81.6 watts/hour (24 volts x 3.4 Amps = 81.6w). The SainSmart/TS100 consumes 65w on average at 24v, which means that there will be more or less 1h15 of autonomy. Links for parts: Cable AWG 20 red and black: https://www.aliexpress.com/item/32897218954.html Cable to connect the TS100 to the battery: https://www.aliexpress.com/item/33008425360.html Charge/discharge controller (BMS) (6s, 24v): https://www.aliexpress.com/item/32955184179.html 18650 battery (li-ion 3.7v): https://www.aliexpress.com/item/32925707798.html Supports for the 18650 battery: https://www.aliexpress.com/item/32981104293.html Connector for the SainSmart/TS100: https://www.aliexpress.com/item/32833557193.html Connector for the battery (original Amass) (XT30U): https://www.aliexpress.com/item/32962152907.html Kit of screws M3: https://www.aliexpress.com/item/32799402476.html