Bathroom Sink Faucet Knob

thingiverse

This is a straightforward faucet handle for my basement sink. It features a simple on/off design with separate hot and cold water controls, activated by pulling the handle down to turn off or pushing it up to turn on. The handle attaches to a metal cylinder via a screw and hex nut combination, ensuring a secure connection. A removable cover bearing 'H' and 'C' markings is included for easy identification of the hot and cold water settings. Print Settings Rafts: Don't use them if you can avoid it Supports: Always go with yes when available Infill: Aim for at least 30% to achieve a strong and durable build Notes: * I built this part using a Flash Forge Creator Dual. * The ABS filament was set to 230C, while the print bed was heated to 110C. * A 10% infill was sufficient, but a cap with higher infill is recommended. * One support layer was necessary due to the internal design's requirement for full support. * With a .30 layer height and feed rate of 50/75, the print took about two hours and fifteen minutes. * I don't recall the exact amount of filament used, but it was over 14 meters.