Basic Filament Spool Holder

prusaprinters

<p>Hello guys &amp; gals :)</p><p>This is my everyday Filament Spool Holder. It is heavily based on the design by <a href="https://www.printables.com/model/4583-drybox-for-prusa-printer-enclosure-v2-with-humidit">Ondřej Stříteský</a>, and it uses the same mechanical components.</p><p>Print the design using any filament (PLA is good to go!) with the settings of your choice. It's rigid enough to use low infill. Assemble it with 4x 608RS bearings (they clip nicely into their sockets!) and 2x 100 (length) - 7.8mm (OD) aluminum tubes. Put your spool on top and enjoy!</p><p><i><strong>Release history</strong></i>:&nbsp;</p><p>V.1.1 — 08/11/2022 — Added higher side-walls for the filament spool not to jiggle when it's almost empty. First public release.&nbsp;</p><p>V1.0. — 11/10/2022 — Initial release. Did not publish.</p>