baseplate Bosch GKF 12V-8

thingiverse

!!!!!!!!!UPDATE!!!!!!! https://www.thingiverse.com/thing:3730951 new better version!!!!! (still in work) I just need a circle jig for my small handrouter, so I redesign the baseplate (original is black) to mount an 8mm threaded rod. I print it with 100% infill for maximum strength and just a small support at the ground. I clean the holes after the print with 4.5mm and 6mm drillbit and countersink all. Attention!! *update I add a new version of this plate, because the first one wouldn't give me the result I want to. The new one is much better than the first but with the old one you can make it for your own. In the new version, you can now set the circle point better and easier. You can use M6 screws and wingnuts to tighten the sliding circle point. You should drill all holes again appropriately in the sliding bar with 5mm to get a shelf pin in there. Your printer has to be calibrated for perfection.