Based Openforge 2.0 Dungeon Stone Floor and Corner

thingiverse

IMPORTANT: ========== This does require supports, but only for the bottom, make sure to use support blockers for everything but the bottom. Summary ======= It got annoying having to put 4 pieces together to make 1 corner piece (that does not make any squares on that corner piece smaller) at the table, so I made it in blender. I also made a wall + floor piece for the same reason, also included. The files used: dungeon_stone_wall.inch.A.openforge.side.stl dungeon_stone_wall.column.inch.L.stl dungeon_stone_floor.inch.E.openforge.stl dungeon_stone_base.inch.A.openlock.magnetic.stl NOTE: Even though I used the Magnetic side base, this piece is NOT magnetic, those areas are filled in and removed. It was just a lot more sturdy than triplex and doing this makes a pretty big print. I couldn't use base.plain.square.inch.2x2.magnetic.openlock.stl because this is an extra 0.5 inches, so had to make a custom base with the dungeon_stone_base.inch.A.openlock.magnetic.stl. Again, this is NOT Magnetic.