Base for tower lamp

thingiverse

Added a cover for the lamp designed again in Tinkercad see poly twist.stlThe base with the triangle corners does not print properly - the triangles seem to be protruding below the base of the thing like stilts - use the one with square corner posts.I made this to fit a spiral vase accordion tower with 81mm square base to turn it into a lamp.The base has a lid with 42.5mm hole into which a 230mm plastic pipe can be slotted - the pipe holds an LED strip wrapped around it - the wires from the strip feed through the hole to the electronics in the base - there is a 8mm diameter hole for fitting a PSU panel jack.The top is a push fit into the base - might need a minute bit of sanding.The new top part now has a built in tube.Thanks to CADNurd for his accordion vase which I used to make my lamphttps://www.thingiverse.com/thing:4852334Added a centre pole with a spiral slot for the led strip which holds 56 leds from a WS2812B 60/m stripAdded two new covers