Base for minis

prusaprinters

<p>Simple bases (25,32,60mm) with room for washer (M10) and magnet (4x2mm) in the bottom. They where a bit tricky to slice, but Cura 4.3 made a far better job of it than Cura 4.2.</p> <p>Attach washers before magnets to make everything a bit easier for yourself. A simple trick to attach the washers is to heat them over a candle for half a minute. They will partially melt PLA and stick when it solidifies. Do not try to do this with magnets, as they loose their strength. PVA glue does the trick.</p> Category: Games