Base for Fabrikator Mini, supports Smart Controller and 40MM fan

thingiverse

This is a base for the Fabricator mini, which requires a larger printer (5.7 x 8 build area) to print it out. It comes equipped with a smart controller and a 40 mm fan that gets its power from the motherboard. You can find more information about installing the smart controller in this YouTube video: https://www.youtube.com/watch?v=IEodObbV7WA The fan works best when used to pull air out of the printer, as shown in the last picture. Some unscientific testing resulted in motor temperatures that were 10-20 degrees Fahrenheit cooler than stock when using the fan. I used a 12V fan and wired it directly to the power input on the board so it runs whenever the Fab Mini is plugged in. If someone was cleverer, they could have it intelligently controlled by the motherboard. If you'd rather buy a printed base, I'm selling them on eBay: http://www.ebay.com/itm/141943891463?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649 Print Settings: Printer Brand: MakerBot Printer: MakerBot Replicator 2 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: fast Infill: 30 Post-Printing: Install inserts. I use mcmaster carr #4 heat set inserts with this base, but 3 mm should also work well. I just install the inserts using a soldering iron.