Barrina T8 LED Tube Standoff

thingiverse

Various sized standoffs for the Barrina T8 branded LED tube lights readily available. The different heights should allow you to bypass any conduits/obstructions in your shop. I recommend to print these in either PETG or ABS as PLA might be a little too brittle. Print settings: 0.3mm or 0.2mm layer height, no supports, 5% infill works fine to save some print time. Mount the clips on the LED tube BEFORE you install the lights, i.e. do not install the clips without them being on the LED tube already. It's super hard to align them correctly otherwise and you'll risk just snapping off the supports. Holes are sized for drywall screws. When installing make sure you set your clutch on your driver to a relatively low setting since the plastic will easily split otherwise. These clips were designed to take a minimum amount of space, not to hold up against high torque drivers :-)