Barenpark Insert (Remixed from karlbibby)

thingiverse

You will print each part once. I redesigned this in Tinkercad to save plastic and reduce print time. The corners are rounded to minimize warping, so a Raft is not required. This version uses about 8-10% less plastic and prints in about 8-10% less time. The photos show the use of Inland PLA+ True Red. I used settings of 205 degrees and 60 degrees. 0.3 mm at 70 mm/sec with 10% infill and a brim. This saves about 33% of my print time. Caution, I removed a lot of space for easy access on Barenpark_Remix_1.... HIGHLY recommend waiting until it cools completely before removing from the bed after printing or else you risk bending it. It is sturdy enough once cooled.