Barbie quiver

myminifactory

This model was designed to complement the Barbie recurve bow (Faire Play Recurve Bow by zheng3). NOTE: This model does not include the bow. The quiver can be printed without supports, in a vertical orientation. The holes for the straps can easily accommodate 3mm (⅛") ribbon, craft leather or cording. The 'arrows' shown in the images are craft skewers with the tips sanded (for safety) and cut to approximately 11.5cm (4½"). The cavity holds 8 skewers comfortably. A small slit is cut into the end of the skewers so they can latch onto the cord on the bow. IMPORTANT: Please use any 'arrows' cautiously with the bow, as I have discovered the projectiles can go quite far (almost 10m with good stringing!). They definitely should NOT be pointed at a person, because they could cause damage to eyes or other sensitive body parts. Model dimensionsHeight: 100mm (~4")Outer diameter: 15mm (not including strap loops)Internal cavity height: 95mm (~3¾")Internal cavity diameter: 10mm Sliced with PrusaSlicer at 0.15mm and 20% infill, this takes approx. 1hr 20mins to print (1hr at 0.2mm). This is my first model, so feedback is welcome!