Barbie Leg Cast: Split

thingiverse

My daughter was using paper towels around her favorite Barbie Skipper when she would get hurt. I printed the original design by texano but this one only works with dolls that have the articulated ankle or the foot sloped for heels. Skipper, however, has a fixed flat foot and I could not get the leg into the printed cast. I am only 2 weeks into this hobby and really just took a blind try at this. Not pretty, but it is functional for now :) Split it in half. Made cube holes and used the same cubes on the other side on top layer, slightly smaller to create the pins .After the print, I had to clean up the little pins and it took a good shove for it to "snap" the first time. It now snap in ok. Not sure how long it will last but there we go.