Barbie Doll Laptop (Foldable)

thingiverse

This is a reinterpretation of the Barbie Doll Laptop computer. I re-sized it to 1:6 and altered the hinges to allow opening up to approximately 100 degrees. To assemble the two pieces, insert lengths of 1.75 filament into each end, then cut flush. Next, use a #8-32 bolt, heating the end with a flame, to create a dimple in each filament end that will bind it to the display piece. (Note: After printing, if you need to clean up hole I.D.'s before inserting filament, use a #50 drill bit.) Print the Display and Base separately. The other two models are merely illustrations of the finished assembly in open and closed positions.