Barbell nut & bolt

prusaprinters

<p>I found that my old Wieder wieght set had broken nuts/bolts that hold the wieghts on the bars. This is a replacement.</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>DaVinci 1.0 / Repetier</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>Yes</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>.2</p></div> <p><strong>Infill:</strong></p> <p>bolt: 100% nut:30%</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>You can print without supports but it looks better with them.<br/> The nut part should be at least 20% infill with 3 outer layers, 7 top/bottom layers, while the bolt should be solid. I printed one in PETG which is the strongest but I also used ABS. If the bolt isn't solid it will snap with any sideways force. 100% infill for the bolt. <p>ABS doesn't supply much friction on the steel bar but it does hold. If it doesn't you could use a bit of tape on the bar and then slip the bolt on the bar and tighten it down.</p> </p></div></p></p> Category: Replacement Parts