Baofeng UV-82HP Holster

thingiverse

Here is my design for a carrier for the UV-82HP radio made by Baofeng. The back should fit most MOLLE webbing as well as standard 40mm waist belts. I have had a little bit of light shine through from the screen with certain filaments at less than 100% infill, but I assume that the reader posses tape and the experience to use it efficiently. Or, print at 100% infill. Both should work fine.The retaining band is a special rubber band with a large head on one end, but I'd reckon that a normal rubber band with a knot or two tied in one end would work fine too.