Bandito Betafpv dual-stack TPU parts for 3 inch propellers

thingiverse

These TPU components enable the installation of a dual-stack Betafpv board, effectively upgrading your Bandito 2.5 inches to a powerful 3-inch drone. You will need to use longer standoffs (rear) and screws (4) to accommodate the entire stack and VTX. The VTX holder keeps everything in place, eliminating the need for bolts. This setup also allows you to secure a small buzzer. The canopy is a remix of the original design found on https://www.thingiverse.com/thing:3602818. I advise against using the holes for receiver antennas due to their proximity to the propellers. The battery holder is a remix from https://www.thingiverse.com/thing:3608599. To attach it, use four screws/bolts with flat-heads. I have tested this holder with various 2s battery sizes and included a battery protector for those using the original battery holder that employs a battery strap (https://www.thingiverse.com/thing:3602831). The receiver is positioned below the ESC. Testing has shown no signal issues. A spacer is also included for use with the rear screw. These TPU components are designed to work seamlessly with: - Betafpv dual-stack board - TBS Unify Nano32 VTX - Caddx EOS2 camera Feedback and comments are welcome. I appreciate your input.