BANDIT SPEED KIT

cults3d

Outfit your Traxxas Bandit for some serious speed with these 3D printed parts. This includes upgraded wheelie bar and air splitter as well as ground effect plaits that are only available in this kit. Aditional hardware for mounting and assembly are listed below. These parts where specifically designed to be functional yet easy to print. All parts have been rigorsly tested in both "speed run" and "drag race" applications. -TRAXXAS WING- This is a three-piece wing designed for the Traxxas BANDIT and the (1:10) / (1:8) scale E-Revo. If placed diagonally on the print bed it will print on the Ender 3 and other printers of a similar size. For best results print the wing using PETG or CF-Nylon and the blades from TPU. I specifically designed this wing so it could be printed completely from TPU to make an extremely durable wing while still providing significant downforce. ADITIONAL HARDWARE NEEDED Eight 3X10mm screw (ONE TRAXXAS PART NUMBER 2587) Eight 3mm nut (ONE TRAXXAS PART NUMBER 2744) -BANDIT AIR SPLITTER- This is a functional air splitter for the Traxxas Bandit. It will also fit the Traxxas 2WD Rustler but will require running front wheels from the Bandit. This splitter can be adjusted to produce significant down force to keep the bandit on the ground at high speed. It works best when used with a more aggressive rear wing. It is recommended to lower the ride height when using this splitter. This can be achieved by limiting straps or internal shock limiters (fuel tube on the internal shock shaft). MATERIAL: For the best possible material use CF Nylon. PLA, PETG, ABS have been used with great success. Both the mount and splitter can be printed without support material. Will print on a Ender 3 or similar printer. ADITIONAL HARDWARE NEEDED: Two 3X32mm screw (ONE - TRAXXAS PART NUMBER 3964) Four 3X20mm screw (ONE - TRAXXAS PART NUMBER 2580) Two 105mm turn buckle (ONE - TRAXXAS PART NUMBER 2339) Four tall hallow balls (ONE - TRAXXAS PART NUMBER 5355) -TRAXXAS WHEELIE BAR- This is a wheelie bar for all Traxxas 2WD 1:10 scale cars and trucks. Works with the stock Traxxas motor guard / wheelie bar mount. Pictured on the Traxxas Bandit and fits the Rustler, Slash and Stampede. This wheelie bar is designed with drag racing or speed runs in mind. ADITIONAL HARDWARE NEEDED: One 4X20mm screw (TRAXXAS PART NUMBER 2589) One 3x15mm screw (TRAXXAS PART NUMBER 2579) Four 3x20mm screws (TRAXXAS PART NUMBER 2580) One 4x8x3mm bearing (TRAXXAS PART NUMBER 7019) -TRAXXAS BANDIT GROUND EFFECTS- Significantly increase down force on your Traxxas Bandit. Take advantage of ground effect with these plates available only in this Bandit speed kit. ADITIONAL HARDWARE NEEDED Four 3X10mm screw (ONE TRAXXAS PART NUMBER 2587) or Two sided servo tape.