Banana Split Boat

prusaprinters

<p>A bowl for your banana split! This is a pretty good size bowl so you can go nuts building the biggest sunday possible. I fix on the MK3 build plate left and right, but it does go right to the edge. It's a very easy print.</p><p>I used PLA to print these, they were intended for single use, but with warm water and soap you should be able to clean these up for a second use. As always, be careful with 3D prints and food.&nbsp;</p><p>I printed these bowl with enough tops and bottoms so there would be no infill. (I just set them to around 12) Also with the perimeters. I set them so it would be solid. This was to avoid leaks and the bowl is water tight and pretty heavy. Takes about 8 hours to print.</p>