Bambu Poop Chute

prusaprinters

Since I have the left side of my Bambu up against a wall, I needed to get the poop out easily.  So, I just dump it through the crack between the table and the wall.  I have a cardboard box under the table to catch everything.You can update the model to fit your situation here on OnShape - https://cad.onshape.com/documents/ca048f137ebdf4a324a3f568/w/bf3700028f178d48637fb435/e/6ca44c36f7532d1eaf5a47f1?renderMode=0&uiState=6678584a4fdfc82ea35c5cbbThis model is for a printer that is 130mm from the edge of the table and with a 25mm gap between the table and the wall.I am using 12x2mm magnets superglued to the part - https://www.amazon.com/Grtard-Magnets-Neodymium-Whiteboard-Magnets-12x2mm/dp/B0B715S4V9/ref=sr_1_6?crid=1PFZ482MGUCRL&dib=eyJ2IjoiMSJ9.xBKO9T4JS6qZeiTLVkJgAwcwFvDck3mPiPxO_STv-lNILAvdAHzyRz5Q8t2-A4yOjDinp7H05XSgM8u0Ak1itisLyDNJik6MAadElfeSZLGmjkjy4tc5mONmVfZMb2sHEqsKK3dmHVy9b7F660HjraI0X0gl_M09CLlNLeiN-mKvP-6MJNAvUCyvu-1pPRabphtXlFhnv5mY-7v-W19E4o7PV8hTfuY4nO_USgMI5GzJ2Jd_jhGjc4QMURNShIYu309OobRz17AQC1v9jOipaA1x-OGD9f0lK9kKnX-tIyQ.rOQMt0FmGb9-mXlxhzKkaJqwvS6t3u-OCRgzpoPJ0tE&dib_tag=se&keywords=12mm+x+2mm+magnets&qid=1719163186&sprefix=12mm+x+2mm%2Caps%2C153&sr=8-6Supports - I printed it standing upright, but it could probably be done differently.  I just added a Support Enabler rectangle up the back just to add support.  It was just down the middle since the angle is not terrible.FYI - The model in the picture is 20mm shorter than the one uploaded here.  I updated the model after the print.