Bambu Lab P1P LED Light Front Upper Mount Bracket and Diffuser

Bambu Lab P1P LED Light Front Upper Mount Bracket and Diffuser

prusaprinters

I wanted to move the Bambu Lab LED light strip to the upper front bar of the P1P. Having seen @3DSourcerer's cable management plate I thought that seemed like a good way to mount the light bar. Other solutions I saw needed double stick tape. This allows you to easily snap the light bar in and out as needed. I utilized the same 3 mounting tabs already on the machine and the light bar snaps into place. The PCB of the light strip snaps into the light bar, and the front diffuser rotates and snaps into place on the light bar. I printed both in PETG, with the diffuser in white, but translucent would work OK as well. There is some light visible in the camera from the left hand end of the light bar but it's really only being used for monitoring prints anyway with the quality of the camera. There should still be room behind the light bar for USB cable management as in the original model. Both parts print face-down on the build plate. I used .08mm layer height since I wasn't in any rush. The lens does need the smaller layer height as the lens itself is thin to allow light transmission. First two photos show a cross section print test of how the lens locates into the ridge along the top of the bar, then rotates down to snap in along the bottom. The connector and wiring can pass through the light bar and be fed up and over the PC Board to install the connector.

Download Model from prusaprinters

With this file you will be able to print Bambu Lab P1P LED Light Front Upper Mount Bracket and Diffuser with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Bambu Lab P1P LED Light Front Upper Mount Bracket and Diffuser.