Balloon Girl Visualizes Extruders Motion

prusaprinters

I like to see the extruder's movements and this is a tiny print to allow that.Some extruders have a long axis where you can even fix a knob or while at but others are short. But if you look at it the axis has a little spare bit on one side and it actually reaches down at least 7 mm. This is where this visualizer gets fixed in.The print has fine lines so should be done with 0,1 mm layer height and 0,3 mm line width and also select ‘Print thin walls’. . Additionally I set the feed rate to 50% in octoPrint with those fine prints.Still prints fast and uses 0,46 gr filament.Cutting the bottom tip with scissors into a V shape (just a tiny bit!) may help inserting the piece. Have a calm hand and try again.I reused the shapes from banksy Balloons girl (which in turn I picked up somewhere on the net) but the original artwork can be found at Flying Balloon Girl