Balancing Bird With Tree Stand

thingiverse

I'm thrilled to share my perfectly balanced bird, functioning at peak performance!\nThe center of gravity is expertly calibrated across varying weight ratios. Parts 1-2 are engineered with lower weights, while parts 3-4 boast higher weights.\nMy bird model is based on Peter Behrens' original design found at http://archive3d.net/?a=download&id=58b6be71\nI employed CuraEngine to refine my settings:\nNozzle: 0.3mm Filament: 1.75mm Layer Height: 0.2mm Top/Botton Thickness: 0.4mm Infill Overlap: 15% Supports: Yes Brim: No Raft: No Part 1 and Part 2 specifications: Shell Thickness: 0.5mm Infill Density: 25% Part 3 and Part 4 details: Shell Thickness: 0.6mm Infill Density: 98% The tree stand (Part 5) is ready to print, feel free to customize as desired! A crucial note: To maintain balance, after slicing each part1/2 requires filament without support or skirt: 1815mm ±10mm. Each part3/4 necessitates 4315mm ±10mm. If not, you may need to adjust your settings. Print Settings: Printer Brand: RepRap Printer: Prusa i3 Rafts: No Supports: Yes Post-Printing Instructions: Connect the parts by centering Part1/2 with a piece of filament and super glue. Join the two remaining parts using super glue, securing them in place. Good luck with your assembly!