Balance Board Base

thingiverse

Hey Folks, due to boredom and home office laziness I made this fun balance board. You just need some kind of round plate (preferably wood) with about 400mm of diameter to screw it to. I used 15mm plywood and 3.5x16mm wood screws. The smaller you make the plate, the harder it gets to balance! It´s also a nice stress test for your printed part... But after 3 weeks of use I did not discover any problems If you have a wooden floor or anything else that could get dented by plastic: sand down the layer marks on the bottom! This makes it harder to balance and less likely to scratch your floor. If you break your bones (or anything else) while using this, it´s your fault, not mine :-) Strictly no responsibility, just providing possibilities. If the part failed because you used to little infill, it´s your fault as well, but please comment for others to find the limits. Final advice: If you find the surface to be slippery, add some epoxy resin to the wood and sprinkle on some bird sand. Brush of well when dry and you´re left with something between skateboard and sandpaper.