Balance arm for Horus X10

thingiverse

The Horus controller is enormous, making it extremely unstable when using a neck or shoulder strap. I urgently needed a balancing arm that would be incredibly robust and fit snugly in the tight space surrounding the small hook loop. This design was specifically created for my large Tarot shoulder strap hook and would not accommodate smaller hooks. Print in black! I've just run out of filament, ironically. Printing Requirements: Use a layer height of 0.15 or less. Infill more than 60%. I opted for an infill of 80%. Support material should be used over 70 degrees, but only underneath the arm. Support material must not be used in the screw holes or inner block. Thread one M4 hole and drill the other to a diameter of 4mm.