Badge holder for 3rd gen adorable motoring vehicles.

thingiverse

The existing badge holders seem to be designed for 1st and 2nd generation models. To address this issue, I created a 3D printable holder that offers several benefits. One notable advantage is the ability to install it without removing the grill. The following steps outline the installation process: 1. Purchase a badge on Amazon or a similar platform; the cost should be approximately $9. While some badges feature magnetic properties, this holder can accommodate non-magnetic badges. 2. Print the holder using PETG or ABS materials (PLA may warp over time and is not suitable for UV exposure). Ensure that you print it with supports in place and orient the front side upwards. 3. Attach the holder to the grill using two quick ties; once they are secure, rotate them so they are fully recessed within their channel. 4. Apply glue (I used Shoe-Goo) or epoxy to the front of the holder, then gently push the badge into the recess. Use blue tape to hold the badge in place until the glue dries. 5. If you need to remove the badge at any point, there is a slot at the bottom of the holder where you can insert a screwdriver and turn it. This design should accommodate standard badges, and I have also created additional variations available on Thingiverse: https://www.thingiverse.com/thing:3272065