Badge holder

prusaprinters

A simple badge holder with 20 hooks. It has a roof preventing the gathering of dust on the badges. The hooks are curved back to keep the badges fixed. Print Settings Printer: Heavily modded Craftbot Rafts: No Supports: Yes Resolution: 0.3mm Infill: 15% Notes: Print turned on the side to keep the supports to the minimum - this way they are minimal, only needed under the hooks. Use any resolution you like, but this is a big print, so it will take a while. Do not print faster than about 50 mm/s or the rather thin print will move and the surface will be rough. Post-Printing ============= Clean up the print and glue it to the wall using either Tesa strips for posters (removable) or some silicone. Category: Jewelry