Badge carrier iPhone 6 cover

thingiverse

Unless it's something like my own birthday, I'm not a very forgetful guy, but when there's that once-in-a-blue-moon moment where I was running late and happened to leave my company ID badge on the kitchen counter, it can throw my whole day off. Wouldn't it be nice to seamlessly tie my badge to something that is always a part of my being so that never happens again? I know of only one thing that never leaves my side... the smartphone! As there is no badge-holding sleeves on the market today that don't bulk up your pocket with their over-size designs, I've made this perfectly sleek and streamlined cover that you can slip the badge ID into first and then clip your phone inside after that. The badge is physically exposed so you don't have to wrestle with the door scanner. One thing I'd recommend, however, is printing in Ninjaflex or some kind of rubber alternative to ABS (or PLA) because it's really tough to slip your phone in there if it's too stiff. Dimensions fit a phone that is 138.1 x 67mm x 7mm (aka - iPhone 6) If you found this useful, please share and be sure to peruse my other submissions which are almost as varied as they are many: http://www.thingiverse.com/3E8/designs Or, if the Spirit moves you, please feel free to dump a bitcoin or two here: 1Py3TUeR8noBN2giHyFV1GfB6x3Kh2WEVv Enjoy! February 25th, 2017 update: Added an open-bottomed version that you can print in ABS (PLA is probably ok too) that the phone can easily snap into at the bottom. Again, the full seal deal is more suitable for a flexible material. I'm just adding this one for those rigid-filament purists out there... September 26th, 2017 update: Added an open-slotted version that you can print entirely without support. It's my new favorite.