Backgammon Board

thingiverse

# To Print * 30 pieces are required, 15 of each if printing in different colors * 2 large bowties are needed * 2 small bowties must be printed * 2 board halves are necessary * 2 mirrored board halves need to be printed * 24 triangles are required, 12 of each if printing in different colors # To Buy * Optional: These magnets from Amazon (https://www.amazon.com/gp/product/B077LCCGMM) * Dice can be purchased on Amazon at https://www.amazon.com/gp/product/B07CGYBNCF # Printing Instructions Magnetic filament was used for the triangles, which were later painted with spraypaint. Any colors and plastic types can be used during printing. A minimal amount of support material is required where the bowties are inserted. # Assembly Instructions The magnets should fit into the pieces without any glue. Ensure all magnets face in the same direction to allow stacking. Some sanding was necessary for the triangles to fit properly, but not much. No glue is needed here either. Bowties require epoxy, although this is optional. One half of the board was left unglued from the other so it can be removed and folded over with a rubber band for storage