Babyphone Camera Holder

prusaprinters

Easy to print, no supports, all bolts printableIdeaNewly made dad who didn't feel like spending money again for a simple holder and also didn't wanted to drill holes in the wall.I made the first version specific for the Momcozy Setup, but didn't like that you saw a bolt in the view.This new version don't has this problem anymore and is compatible to many more Cameras that have the 1/4-20 UNC Thread. I modeled a Hirth Joint between the camera platform and the base with 20 clicks to adapt the angle.The partsClamp baseBase topCamera platform1x big 20mm bolt, easy turn-able with your hand1x 6mm bolt to connect base with top1x 10mm bolt with handle to adjust camera angle1x 1/4-20 UNC camera boltHow to assemble?Verify if the bolt holes don't have small filament pieces, if so, remove them with a cutting toolCheck all bolts before assemble in there holes, sometimes you need to turn them back and forth a bit (i removed between 0,05-0,1 mm on all bolt threads - needed when you 3d print bolts)Connect base top to the base with the 6mm bolt - 5mm Allen Key needed (the 6mm is longer than the 1/4-20 UNC bolt)Screw the 20mm bolt in the baseConnect you camera to the platform with the 1/4-20 UNC camera bolt - 5mm Allen Key neededNow connect platform to top base with the 10mm bolt with handleTight all bolts Carefully, no need over tighten. What do you need?Parts and bolts should be printed with different settings. Bolts need to be strongerPrinting instructionsI printed all on an Creality K1Filament i used is Creality PLA+ WhiteCertainly you can use your own filament with your settings. The table below are my setting which give me good results for the bolts.PartsQualitySupportInfillBrimWallsTop-/Bottom LayerBase / Top / Platform0.16mmNo25% GyroidNo34-6Bolts0.16mmNo50% GyroidNo45-6