Babyhawk-R Runcam Split Mod

thingiverse

#BABYHAWK-R - RUNCAM SPLIT MOD ###**WITH SNAP-ON LED STRIP HOLDER** For Runcam Split 2 Mini / 3 Micro (single board version, 19x19mm lens), available here: https://bit.ly/2TOn07e This mod lets you install a Runcam Split to your Babyhawk-R and additional LED strip. The Eachine Aurora strip fits perfectly: https://bit.ly/2wDJShQ. Two antenna tubes at the rear hold diversity antennas in place. It's lightweight but solid when printed with ABS and Acetone smoothing. Keep in mind, this frame isn't for hardcore stunts; it's designed for smooth video recordings with your Runcam Split. Place the Runcam board at the bottom and stack other boards on top. The optional LED clip attaches to the rear pillars of the canopy (snap-on design) if you want a LED strip too. It can be attached/detached easily without disassembling the canopy again. ###**UPDATE** Added another canopy version (V2), allowing for higher camera position. ###**NOTE** This model prints fine with Cura, but it's not optimized yet. Other slicers might complain. I'll clean up/optimize the model as soon as I have time. Happy flying!