Baby Monitor Angled Support for Shelf

thingiverse

I needed a device my baby monitor could connect to, mounted above my toddler's reach on a shelf. I didn't want to install it on the wall and be stuck repairing the holes left behind. This was the solution I came up with. The camera slides smoothly onto two tabs attached to the angled surface at 35° and stays securely in place. The two tabs do require minimal support for proper printing, but this is still a straightforward print that takes mere seconds to remove the support material. It doesn't need much infill either; I printed it with 8% infill at a 0.15 mm layer height.