Baby Gym

cults3d

This gym is perfect to mount on your baby's room, a fun play area that will help develop leg strength to stand up and take the first steep. Printed brackets are used to mount the mirror o the wall and hold the rods for the structure. #FLASHFORGECULTS The parts needed for the whole gym set are: *All printed parts, 2x "R_bracket" and 2x "L_bracket". *3mm Acrylic mirror as big as you want. (Is safer than a glass mirror). *18 mm rod or pipe for vertical stand, around 60 cm long. *2 x 22 mm rods or pipes for horizontal railing, same size as the mirror. *10 x 3/16" screws and anchors if needed. *10 washers. *4 #6 x 1/2" flat-head screws. Instructions: 1.- Use some mounting glue or 2-side tape to hold the mirror while mounting brackets. 2- Mount the "lower_bracket" at the center of the lower edge of the mirror. 3.-Cross the vertical rod through the "lower_bracket" and glue the "leg" at the base of the rod. 4.-Slide the "Center_bracket" by the smaller 18mm hole to the vertical rod. Screw the bracket at around 40 cm height, at the point where your baby can reach the first Horizontal rail while sit or crawling and help him stand. 5.- Screw the the "Upper_bracket" on the top end of the rod. This height should be to hold the upper horizontal rail, for baby's support while standing-up. Make sure both Center and Upper brackets ate aligned. 6.- Slide the 2 horizontal rods through the holes of the installed brackets. 7.- Insert the ends of the rods L and R brackets and mount them on both edges of the mirror at the proper height. 8.- Screw the top and center brackets to the horizontal rods. 9.- Glue the leg to the floor.