BA/BF Falcon/Fairmont/Fairlane Ghia cupholder clip fix

thingiverse

G'day guys. I got sick of my cup holder not staying closed in my BF Fairlane so I decided to do something about it. This is a direct replacement for the current male end of the clip for the closable cup holder tray. PRINTING INSTRUCTIONS I printed this on a Longer LK4 Pro (Ender 3 V2 clone) using 0.08mm layer height and 100% infill. Only took 8 minutes. Your mileage may vary, but it should turn out alright. No supports required. Printed in black PLA+. INSTALLATION INSTRUCTIONS To install, just snip off the old male clip and sand the nub down flat. I recommend sanding the bottom of your printed piece as well for maximum adhesion, especially if you're printing on a glass bed. Once both pieces are sanded and cleaned, just glue the new bit on where the old bit was and vualah! The glue I used was 2 pack epoxy from Selleys. Your mileage may vary with this as well. Feel free to let me know if this doesn't fit, or if there are any other obvious flaws! :)