B&G Tactical parts

thingiverse

A few "Tactical" parts I made for my pest control friends. All parts were designed to fit a B&G wand with 10mm diameter with the 15mm diameter end. (May fit AIrofog and similar as well but have not been tested) **Current Parts:** - **Crosshair:** Fun esthetic piece made to fit the end of the wand. I printed it with no infill, no top and bottom layers and thicker walls, can be printed with infill and top/bottom layers. - **Simple Clip:** Designed to fit on main portion of wand, I have 3 current sizes and can make more if requested/necessary. Current Sizes are 30mm, 25mm and 22mm. 30mm was designed for 1-1/8 to 1-3/16 (May fit 1-1/4") handled lights such as the Streamlight Striker/Stinger. 25mm should fit 1" handles such as the NightStick TAC560xl, and OLIGHT Baton 3. 22mm is for small (3/4")tactical lights such as the Streamlight ProTac 1L. - **Offset Clip:** Designed to fit near the tip of wand, offset is to move the lens of the light away from the tip. I have 2 current sizes and can make more if requested/necessary. Current Sizes are 30mm, and 25mm. 30mm was designed for 1-1/8 to 1-3/16 (May fit 1-1/4") handled lights such as the Streamlight Striker/Stinger. 25mm should fit 1" handles such as the NightStick TAC560xl, OLIGHT Baton 3 etc. **All test prints done with .8mm nozzle, If you are printing with .4mm nozzle, you may need to print with infill or double up wall count. For example, I printed without infill and 4 walls, no top/bottom layers. With a .4mm nozzle you'd need 8 walls. ** Non-Commercial. Feel free to print for your own use however you **cannot** sell these without consent.