Azteeg X5 Mini V3 40mm extrusion mount.

thingiverse

This mount is specifically designed for an Azteeg X5 mini that can fit seamlessly into OpenBuilds 40mm VSlot extrusion (2040 or 4040). Use M5x10mm screws to securely attach it to the extrusion. To attach the board to the mount, use M3 x 12mm screws; however, in the provided photos, Arduino washers and M3 x 16mm screws were used instead. On September 3rd, 2016, I made some notable adjustments to this design. First, I fine-tuned the fitment of the ports to ensure a perfect fit. Additionally, I reduced its total height to 32mm by compromising on the mounting screw holes and allowing only two of them. To provide extra support at the bottom, I incorporated nut traps along with a 0.25 mm support layer. Later that day, on September 4th, 2016, I made some further enhancements to this mount's design. Firstly, I added the Open Hardware logo for authenticity and branding purposes. Secondly, I introduced several small 5x5mm extrusions to serve as zip ties for better organization of cables and wires. On the same day, September 4th, 2016, I continued to refine this design by adding more 5x5mm extrusions specifically for securing the three screw terminals on the left side of the board. Finally, on August 6th, 2016, I declared that this mount was almost complete at revision 1.8 and added some photos to showcase its features and intended wiring setup. I plan to add more images once I have finalized all the details and wiring configurations.